PRESS MAINTENANCE

At some point all presses will need to be maintained. Be it grease, sanding, painting, alignment, or one of the many other tasks. This week brings the beginning of my long journey of press maintenance. Our press bed had become a lovely dark grey color, stained with rust, and dirt deposits. Starting in one corner, with 50 grit emery paper, I began to sand… and sand… and I am still sanding two days later. However, it is quite satisfactory to see the glory hiding behind the dirt when the steel starts to shine.

For any printmakers out there that want more information about the process here are some tips:

-ensure the safety stops are in place, and that you wear the recommended PPE (personal protective equipment): respirator, googles, gloves, and an apron.
-Sand the press bed by going with the grain of the steel.
-An orbital sander can be used, but be careful not to over sand sections with this power tool and avoid gouging the bed with the grinding wheel. A belt sander may be used, but personally I’d prefer to use an orbital sander because of its control.
-Ultimately the best method and the one that yields the best results with the littlest effort is to send the press bed to a machine shop that can re-tool the surface to a perfect state

~Kyle,
Studio and Operations Director